JM Oganis

Skip to Main Content »

Phone: 03 9729 7656

Category Navigation:

You're currently on:

LDG AT-200 ProII

Click on above image to view full picture

More Views

LDG AT-200 ProII

Email to a Friend

Be the first to review this product

Availability: In stock

$495.00

OR

Quick Overview

Auto Tuner

Details

Time was, 100 watts was a lot of power. Today, more and more transceivers feature 200 watts output. Even though many of these modern radios feature a built-in tuner, it’s range and features are usually quite limited; if you need a tuner, you probably need a better one than they built into the radio. The LDG AT-200ProII is designed for this new generation of rig. It's specifically recommended for Ten-Tec and tube radios.Many QRP operators have a small 100-150 watt amplifier for times when you need a few more S-units. The AT-200II is ideal for this kind of operation; it’s minimum required power is only 5 watts, but it will handle the higher power as well.

The AT-200II will handle up to 250 watts SSB or CW on 1.8 – 30 MHz, and 100 watts on 54 MHz. It features LDG’s state-of-the-art, processor-controlled Switched-L tuner. It will match virtually any kind of coax-fed antenna, including Yagis, dipoles, inverted Vs, slopers, loops, just about anything. It will typically match a 10:1 SWR down to 1.5:1 in just a few seconds. You can also use the AT-200ProII with longwires, random wires and antennas fed with ladder line with the optional LDG balun.

Operation couldn’t be simpler: while transmitting a carrier, just press the Tune button. An automatic tuning cycle will begin, then end a few seconds later with the tuner set at the lowest SWR (almost instant for frequencies stored in memory).

The AT-200ProII is the latest in a long line of innovative LDG tuners. Get the most out of your Kenwood, Yaesu, Ten-Tec or Icom radios that operate at higher power

Specifications

  • 5 to 250 watts SSB and CW. (100 watts on 6M)
  • Easy to read LED bargraph display for RF power, SWR and status
  • 16,000 3D memories for instantaneous band changing
  • Two position antenna switch with memories for four antennas on each position
  • Tuning time: 0.5 to 6 seconds full tune, < 0.1 second memory tune
  • Built in frequency counter for memory operation
  • Frequency coverage: 1.8 to 54.0 MHz.
  • Tunes 6 to 1000 ohm loads (16 to 150 ohms on 6M), 6 to 4000 ohms with optional 4:1 Balun (LDG RBA 4-1)
  • For Dipoles, Verticals, Vs, Beams or and Coax Fed Antenna
  • Optional external Balun allows tuning of random length, long wire or ladder line fed antennas
  • Optional interfaces for Icom and Yaesu available
  • Power requirements: 11 to 16 volts DC at 750 mA max during tuning
  • Enclosure: 8.5D x 6.0W x 2.0H inches
  • Weight: .91 Kilograms

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

My Cart

You have no items in your shopping cart.

Compare Products

You have no items to compare.

Newsletter

  • Type

  • Brand

Other Items of Interest

 

Subscribe to our Newsletter